Need some help with my Gameshark Pro 3.2.
 

Ok. I've heard that Zelda And Banjo-tooie use the same keycode. But when I loaded Super Mario 64, Selected the Zelda Keycode, Turned off the N64 and, I loaded B-t in the Gameshark and turned on the N64 the game Would not start. I cleaned it, and Everything! And Tryed Sm64 Again But Still no response except for the letter "8". And now I need help. So what should I do? Thanks for any help.

hi acdry

Hello? Anyone there?

Are you sure they use the same? The cartridges, like the Equalizer, will wait patiently for the correct game before allowing you to change the keycode.

This means either you are unlucky and just need to ensure the carts are in correctly, or you will need to buy a game that uses the keycode you selected.

Is there a way to reset it?

Unfortunately, I don't think so.

Whenever the "8" appeared on my Gamesharks, I feared the worst. You will need a game corresponding to the keycode. And, if that's not working, chances are you're stuck.

It's been awhile since I messed around with Gamesharks (I have, iirc, four of them, and only one works).